Automation System Integration Engineering Concepts

-

Comments

Post a Comment

Popular posts from this blog

Introduction: PID Controller Design

-
Image
Introduction: PID Controller Design In this tutorial we will introduce a simple yet versatile feedback compensator structure, the Proportional-Integral-Derivative (PID) controller. We will discuss the effect of each of the pid parameters on the closed-loop dynamics and demonstrate how to use a PID controller to improve the system performance. Key MATLAB commands used in this tutorial are:  tf  ,  step  ,  pid  ,  feedback  ,  pidtool  ,  pidtune In this tutorial, we will consider the following unity feedback system: The output of a PID controller, equal to the control input to the plant, in the time-domain is as follows: (1) First, let's take a look at how the PID controller works in a closed-loop system using the schematic shown above. The variable ( ) represents the tracking error, the difference between the desired input value ( ) and the actual output ( ). This error signal ( ) will be sent to the PID controlle...
Read more

PLC Installation & Commissioning

-
Image
PLC Installation & Commissioning PLC Installation, Commissioning and Recommendations Typical installation Typical installation (enclosure, disconnect device, fused isolation transformer, master control relay, terminal blocks and wiring ducts, suppression devices). Spacing controllers – follow the recommended minimum spacing to allow the convection cooling. Preventing excessive heat (0–60?) C Grounding guidelines. Power considerations. Safety considerations. Preventive maintenance considerations. Commissioning and testing of a PLC system Checking that all cable connections between the PLC and the plant are complete, safe, and to the required specification and meeting local standards. Checking that all the incoming power supply matches the voltage setting for which the PLC is set. Checking that all protective devices are set to their appropriate trip settings. Checking that emergency stop button work. Checking that all input/output devices a...
Read more

PROFIBUS

-
Image
 PROFIBUS PROFIBUS or Process Field Bus was introduced in 1989 and it is sometimes confused with PROFINET. It links plant automation modules with the process control. PROFIBUS uses a multi drop single cable to connect the devices. This method is cost effective especially for larger sites when compared to old methods. Its installation cost is low and it is easy to find faults as well because it is a single cable. Types of PROFIBUS There are two types or versions of PROFIBUS commonly known as 1.    PROFIBUS DP 2.    PROFIBUS PA Here is a brief introduction to both of these types. PROFIBUS DP It runs over two core screened cable that is violet sheathed and its speed varies from 9.6Kbps to 12Mbps. A particular speed can be chosen for a network to give enough time for communication with all the devices present in the network. If systems change slowly then lower communication speed is suitable and if the systems change quickly then effective ...
Read more